Cabling Common Equipment in a Multi Group system Page 213 of 456
Procedure 30
Cabling the Core/Net module backplane
1Orient the cable connector so the strain relief paddle is to the right.
2Partially insert the cable connector so its guides mate to the corresponding backplane connector.
3Apply a small amount of pressure to push the cable connector straight into the backplane connector. You will feel a click when the connector seats.
End of Procedure
Disconnecting cables from the Core/Net module backplane
To disconnect cables from the Core/Net module backplane, you must use the P0741489 Extraction Tool provided, located in the rear of the module (behind the I/O safety panel).
CAUTION
Damage to Equipment
Use the P0741489 Extraction Tool to disconnect cables from the backplane shrouds in NT4N41 Core/ Network modules.
Follow the procedure below to avoid bending or breaking pins when removing cable connectors from the backplane shrouds.
Do not insert the extraction tool unless the cable connector is locked into the shroud.
Do not force the extraction tool deeper than the detent on the cable connector.
Do not improvise with common hand tools.
Communication Server 1000M and Meridian 1 Large System Installation and Commissioning
