Nortel Networks 1000M warranty End of Procedure

Installing a Signaling Server Page 393 of 456

5Set the COM port on the maintenance terminal as follows:

•Terminal type: VT100

•Speed: 9 600

•Data bits: 8

•Parity: none

•Stop bits: 1

•Flow control: none

Note: The CP PM Signaling Server is shipped with the Admin Serial port set to 9600 Bit/s. Other available speeds are 19 200, 38 400, and 115 200 Bits. You can change the port speed using the maintenance terminal. To verify or change the baud rate on a Nortel CP PM Signaling Server, see Signaling Server: Installation and Commissioning (NN43001-312).

6Configure the Signaling Server maintenance terminal. Refer to Signaling Server: Installation and Commissioning (NN43001-312).

End of Procedure

Complete Procedure 74 to connect a Nortel CP PM Signaling Server (model NTDW61BAE5) to the ELAN and TLAN subnets of a CS 1000E system.

Procedure 74

Connecting a CP PM Signaling Server to the ELAN and TLAN subnets of a CS 1000E system

1Connect the Signaling Server to the ELAN subnet.

•if the Call Server is not connected to the Media Gateway Controller (MGC) CE port

—Insert the end of one of the 25-cm RJ-45 CAT5 Ethernet cables shipped with the server (NTDU0606E6) into the ELAN network interface port (ELAN port) on the faceplate of the server

—insert the other end of the 25-cm RJ-45 CAT5 Ethernet cable into the MGC ELAN Ethernet port

•if the Call Server is connected to the CE port

Communication Server 1000M and Meridian 1 Large System Installation and Commissioning