Nortel Networks 1000M warranty Cabling the System Monitor, Off End of Procedure

Configuring the system monitor Page 157 of 456

Table 11

SW2 on slaves—total unit number for the slaves (Part 2 of 2)

Slave unit		Switch position					Slave unit		Switch position
address							address
	3	4	5	6	7	8		3	4	5	6	7	8
31	on	off	off	off	off	off	63	off	off	off	off	off	off

Note: **Slave addresses are 1-63.

End of Procedure

Cabling the System Monitor

The System Monitor (NT8D22) is used to monitor the temperature, power supplies, and blower unit in a column. A series of daisy-chained flat-ribbon cables between each module is used to connect the power supplies and the top cap thermal sensors to the system monitor located in the pedestal. The flat cable routes through the square holes in the rear horizontal cable trough. Figure 63 shows the cabling of the system monitor in a column.

Communication Server 1000M and Meridian 1 Large System Installation and Commissioning