Connecting a system terminal or modem Page 181 of 456
Table 18
Modem Commands
Command | Effect |
|
|
AT&F | Load active profile. |
AT&H0 | Flow control disabled. |
AT&D3 | Resets on receipt of DTR. |
AT&S1 | Modem controls DSR. |
ATS0=1 | Answer after 1 ring. |
ATS2=128 | Escape character = ASCII 128. |
ATS7=60 | Pause one second for carrier detection. |
ATQ1 | Quiet mode. |
AT&W | Store active profile. |
|
|
6Disconnect the power cord and serial from the modem.
7Set DIP switches 1 and 4 to ON (down) and the remaining switches OFF (up).
End of Procedure
Connecting a modem to an SDI port
Use Procedure 22 to connect an SDI port directly (no switch box) to a modem (see Figure 72 on page 183).
Procedure 22
Connecting a modem to an SDI port
1At the remote end, connect an
2At the remote end, connect the cable from the modem to an RJ11 telephone jack. If a cable is required, connect an NT8D46 cable to the modem and to the RJ11 jack.
Communication Server 1000M and Meridian 1 Large System Installation and Commissioning
