Page 180 of 456 Connecting a system terminal or modem
Configuring a modem
Use Procedure 21 to configure the modem. You must configure the modem before you connect it to the Large System. A terminal, such as a PC computer, is required to configure the modem.
Procedure 21
Configuring a modem
1Turn the modem off.
2Configure the modem DIP switches as follows.
•DIP switches 1, 3, 7, and 8 to ON (down)
•DIP switches 2, 4, 5, and 6 to OFF (up)
3Connect an
4Configure the terminal with the following values:
•9600 baud
•8 bits
•1 stop bit
•no parity
5Turn the modem on and enter each command listed in Table 18 with a carriage return (press Enter or Return key).
The modem responds OK to every command (except for the last two commands, ATQ1 and AT&W).
