Nortel Networks 1000M warranty Application configuration

Installing a Signaling Server Page 431 of 456

8Configure the application configuration for this Signaling Server. See Figure 177.

•If you are planning on enabling the IP Phone TPS, Virtual Trunk TPS, and optional Network Routing Service (NRS) applications on this Signaling Server, enter a at the prompt to configure this Signaling Server as a co-resident Signaling Server.

•If you are planning on enabling only the NRS on this Signaling Server:

—If this Signaling Server is to be associated with a Call Server, enter a at the prompt to configure this Signaling Server as a co-resident Signaling Server. After you finished installing the Signaling Server software, you can disable the IP Phone TPS and Virtual Trunk TPS in Element Manager (refer to Element Manager: System Administration (NN43001-332)).

—If this Signaling Server is not to be associated with a Call Server, enter b at the prompt to set this Signaling Server as a Standalone Signaling Server - NRS.

Figure 177

Application configuration

CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)

=====================================================================

Please select the application configuration for this Signaling Server.

Please enter:

<CR> -> <a> - Co-resident (LTPS + VTRK + NRS).

<b> - Stand-alone (NRS only - no Call Server). <q> - Quit.

Enter Choice>

Depending on the application configuration selected, either the

NRS type: co-resident Signaling Server screen (Figure 178 on page 432)

or the NRS type: standalone Signaling Server screen (Figure 179 on page 432) appears.

Communication Server 1000M and Meridian 1 Large System Installation and Commissioning