Nortel Networks 1000M warranty Cabling a Superloop Network Card single column

Page 252 of 456 Cabling network modules and loops

5Install the remaining cables according to the assignments in Table 32 on page 248.

End of Procedure

Cabling a Superloop Network Card – single column

If the system is configured in multiple columns, see “Basic cabling for multiple-row network connections” on page 256.

CAUTION

System Failure

Due to the possibility of EMI/RFI noise, do not route cables from front to rear next to the power supply unit.

Procedure 43

Basic cabling for single-row network connections

1Refer to the work order and the cabling layout shipped with the system to determine:

•each loop number assigned

•the module and slot assignments for the NT8D04 Superloop Network Card associated with each loop

•the location of NT8D37 IPE Modules that contain NT8D01 Controller Cards associated with each loop

2Set the Enb/Dis switch on each superloop network card to Dis.

NN43021-310 Standard 02.01 December 2007