Installing earthquake bracing Page 359 of 456
NT8D64BF Floor Mounting Kit
The NT8D64BF Floor Mounting Kit provides the hardware required to secure a Large System column to concrete floors for
The kit provides four sets of hardware, however, a minimum of two anchors must be used diagonally opposite to secure the column pedestal to the floor. The kit also provides four insulating washers that can be used during kit installation.
NT8D6401 Insulating Washer Kit
The NT8D6401 Insulating Washer Kit is used for attaching the Large System to the floor when the installer is using a third party anchor kit instead of the Nortel NT8D64BF Floor Mounting Kit.
In this case, one NT8D6401 Insulating Washer Kit is required for each pedestal to electrically insulate the mounting bolts from the pedestal casting. Each NT8D6401 Insulating Washer Kit provides four insulating washers.
Installing a non-seismic anchor kit
Follow Procedure 69 to install a Floor Mounting Kit (NT8D64BF).
Procedure 69
Installing a Floor Mounting Kit (NT8D64BF)
1Mark the position of each Meridian 1 column using the equipment room floor plan.
2Mark the location of all four anchor holes for each column using a dark marking pencil.
3
4Make the hole in concrete by using a rotary hammer drill to the following size and depth:
•hole diameter 16 mm (5/8 in.)
•hole depth 50 mm (2 in.)
Communication Server 1000M and Meridian 1 Large System Installation and Commissioning
