Foster FHG 3L manual Modifying the parameters, Procedure for setting the default parameter values

3.Confirm by pressing .

4.The display shows the code of the first modifiable type “C” parameter.

Modifying the parameters.

After having accessed the parameters, either type “C” or type “F”, proceed as follows.

1.Press or until the parameter to be modified is reached, when scrolling through an icon appears on the display indicating the category the parameters belong to.

2.Alternatively, press to display a menu that is used to quickly access the group of parameters to be modified.

3.Scroll through the menu using the or buttons, the display shows the codes of the various categories of the parameters, accompanied by the display of the corresponding icon (if present).

4.Once having reached the desired category, press to move directly to the first parameter in the category.

(If there are no visible parameters in the selected category pressing will have no effect.)

5.At this point continue to scroll through the parameters until reaching the parameter to be modified, or return

to the “Categories” menu by pressing for one second.

6.Press to display the associated value.

7.Increase or decrease the value by pressing or buttons respectively, until the desired value has been reached.

8.By pressing this will temporarily save the new value and return to displaying the parameter code.

9.Repeat the operations point 1 or point 2.

10.If the parameter has sub-parameters, press to display the first sub-parameter.

11.	Press	or	to display all of the sub-parameters.
12.	Press	to display the associated value.

13.Increase or decrease the value by pressing or buttons respectively, until the desired value has been reached.

14.By pressing this will temporarily save the new value and return to displaying the sub-parameter code.

15.Press to return to displaying the parent parameter.

Procedure for setting the default parameter values

To set the default parameter setting proceed as follows.

1.Switch the instrument off.

2.Press and hold the button

3. Whilst holding the button switch the instrument on again until the message ”_std_” is shown on the display.

Note: the standard default values are set for parameters “C” and “F”, on completion it is necessary to change the respective parameters as detailed in the parameter settings table on page 6 and 7.

5