Receiving Inspection

English

NOTICE: This equipment has been tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Sub- part J of Part 15 of FCC Rules and the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference of the Canadian Depart- ment of Communications. These limits are designed to provide reasonable protection against such interference in a residential installation. This equip- ment generates and uses radio frequency and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, this equip- ment may cause interference to radio and television reception. If this equip- ment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Re-orient the receiving antenna.

Relocate the computer with respect to the receiver.

Move the computer away from the receiver.

Plug the computer into a different outlet so that the computer and receiver are on different branch circuits.

Shielded communications interface cables must be used with this product.

WARNING: Changes or modifications to this unit not expressly ap- proved by the party responsible for compliance could void the user's authority to operate the equipment.

After removing your UPS from its carton, it should be inspected for damage that may have occurred in shipping. Immediately notify the carrier and place of purchase if any damage is found. Warranty claims for damage caused by the carrier will not be honored. The packing materials that your UPS was shipped in are carefully designed to minimize any shipping damage. In the unlikely case that the UPS needs to be returned to the manufacturer, please use the original packing material. Since the manufacturer is not responsible for ship- ping damage incurred when the system is returned, the original packing mate- rial is inexpensive insurance. PLEASE SAVE THE PACKING MATERIALS!

NOTE: These UPSs are shipped with the batteries disconnected. The batter- ies must be connected before putting these UPSs into service. Refer to Sec- tion 3 "Installation" for connecting the batteries.