Powercom 800VA user manual Troubleshooting, Storage conditions, Extended storage

10. Troubleshooting

PROBLEM			POSSIBLE			ACTION TO TAKE
			CAUSE
UPS	not	on	On/off/test/silence			Press the on/off/test/silence
LED not light			button	not pushed or		button more than 1 second
			push too short
			Battery	voltage	less	Recharge the ups at least 4
			than 10V			hours
			PCB failure			Replace the PCB, call for
						service
			Load less than 20W at			Normal condition
			battery mode
UPS	always	at	Power cord lose			Replug the power cord
battery mode			AC FUSE burn out			Replace the AC fuse
			Line voltage too		high,	Normal condition
			too low or black out
			PCB failure			Replace PCB, call for service
Back	up time		battery not fully charged			Recharge the UPS at least 4
too short						hours
			PCB failure			Replace PCB, call for service
Buzzer			Overload			Remove the noncritical loads
continuous
beeping
RED LED light			Battery failure			Replace battery, call for service

11. Storage

10.1 Storage conditions

Store the UPS covered and upright in a cool , dry location, with its battery fully charged. Before storing, charger the UPS for at least 4 hours. Remove any accessories in the accessory slot and disconnect any cables connected to the computer interface port to avoid unnecessary draining the battery.

10.2 Extended storage

During extended storage in environments where the ambient temperature is -15 to +30 (+5 to +86 ), charge the UPS‘s battery every 6 months.

During extended storage in environments where the ambient temperature is +30 to +45 (+86 to +113 ), charge the UPS‘s battery every 3 months.

13