Powercom 800VA user manual Rear Panel, External Battery Pack Connector optional

Page 7

REAR PANEL

3.10MAIN SWITCH

3.11REMOTE PORT (COMPUTER INTERFACE)

Provide both RS-232 and relay signal to support NOVELL, UNIX, DOS, WINDOWS and other operating systems.

3.12 TEL./MODEM SURGE PROTECTION

Surge protection for telephone and modem line to have the complete safety connection for INTERNET service.

3.13 SITE WIRING FAULT INDICATORS (RED LED)

It comes on when the UPS is connected to an improperly wired AC power outlet.

Note: This device is available on 110 Vac model only.

3.14 SURGE PROTECTION OUTLET

The full time surge protection outlet provides protection from surges such as those created by lighting or connected equipment which has high initial current. Plug equipment that does not require power during a utility power failure into the outlet. This could include a printer, scanner, fax, audio device and power generator.

3.15 EXTERNAL BATTERY PACK CONNECTOR (optional)

Caution: Use only factory supplied or authorized connecting cable for external battery !

3.16OUTPUT POWER RECEPTACLES

3.17AC INPUT POWER RECEPTACLE

3.18INPUT CIRCUIT BREAKER

It trips when the connected loads exceed the protected receptacle's capacity, The center plungers of the circuit breakers extend when tripped.

3.10 3.15 3.12 3.11

3.10

3.16

3.17

3.11 3.12

3.13

3.14

3.15

3.18

3.13

3.16

3.18

3.17

800VA/1000VA/1200VA2200VA

1500VA

Image 7
Contents USER‘S Manual Please read this manual Important safety instructionsTable of contents Introduction Safety Presentation Rear Panel External Battery Pack Connector optionalInstallation Connect the loads Charge the batteryCheck the Site Wiring Fault Indicator Connect to UtilityOperation Overload continuous alarm AlarmBack UP slow alarm LOW Battery rapid alarmSoftware options Power Monitoring SoftwareInterface Kits SUB 9 Pin Female Connector for purpure cable SUB 9 Pin Female Connector for white cableComputer Interface Port Battery Replacement Extended storage TroubleshootingStorage Storage conditionsSpecifications Page