Hardware Setup, cont’d
Front Panel Features and Basic Operation
There are several features that must be set up prior to using the MLC. Refer to chapter 4 in the MLC 104 IP Plus User's Manual for details.
12
Volume control
C | Volume knob and LEDs — Rotate this knob to adjust the audio |
| volume. Global Configurator allows you to select whether this |
| knob will control the projector’s audio levels or the optional |
| MediaLink switcher’s audio levels. |
| If the MLC is configured for use with a MediaLink Switcher |
| or projectors, the MLC’s LEDs light to indicate volume ranges |
| (with steadily lit LEDs) and minimum/maximum volume limits |
| (with flashing LEDs). |
DISPLAY | |
ON | OFF |
VOLUME
CONFIG
VCR
DVD
PC
1
2
3
4
If the MLC is configured for increment/decrement volume |
adjustment, the LEDs scroll up/down briefly. |
Configuration (host control) port
D | Front panel Config port — This 2.5 mm mini stereo jack | ||||
| provides an | ||||
| An optional cable for this port is the | ||||
| TRS configuration cable, shown below, (Extron part | ||||
|
|
| 6 feet |
|
|
|
|
|
| ||
|
|
| (1.8 m) |
MLC 104 IP PLUS
MLC 104 IP Plus
Front Panel
3 4
1 6
Part
5
9
Buttons
Tip
| The MLC 104 IP Plus controller has backlit buttons. The button |
| caps are removable so the button labels can be changed. For |
| instructions on how to change the buttons, refer to chapter 1 of |
| the MCL 104 IP Plus User's Manual. |
A | Display On/Off buttons — After they have been configured |
| (for instructions, see "Configuring the On and Off buttons" in |
| chapter 3), press the On button to turn the display device on, |
| and press the Off button to power it off. Only one of these two |
| buttons can be selected (active) at once. You can assign other |
| functions to these buttons via the Global Configurator software. |
B | Input selection buttons — By default, these buttons are a |
| mutually exclusive group (only one of these buttons can be |
| selected at a time). |
| Press an input selection button to select the desired audio and |
| video input to the projector or an optional Extron switcher. The |
| button lights brighter and remains lit while an |
| input is selected. |
Ring
Sleeve (Gnd)
Connection | TRS Plug | |
|
|
|
Pin 2 | Computer's RX line | Tip |
Pin 3 | Computer's TX line | Ring |
Pin 5 | Computer's signal ground | Sleeve |
Pinout for TRS RS-232 cable wiring
This port has the following
•38400 baud
•1 stop bit
•no parity
•8 data bits
•no flow control
MLC 104 IP Plus • Hardware Setup |