POSIFLEX Business Machines 16280900030 user manual Routing the Cables, Preparing the Main Unit

15” 2nd LCD Panel

Please follow the installation instruction that come alone with the 15” 2nd LCD monitor LM-6301 to mount the interface bracket kit onto the LCD panel. Fit the interface bracket the same way as joint base of LM-6201 to the rear connect opening and fix with 2 screws with washers. Route the VGA through the cable exit of the base stand to the main unit. Connect the attached power adaptor for its power source.

ROUTING THE CABLES

Place all the cables required for connections to the main unit except those for the integrated attachment through the front part inside the stand assembly. Be sure not to damage any cable during this operation.

Route Cables through Front Part

Connect this End to Main Unit

Now, turn the adjustable stand assembly back to normal orientation and arrange all cables to come out of the area for mounting

main unit from the bottom edge for ease of later operation.

PREPARING THE MAIN UNIT

On the back of the main unit, there is a service wi ndow among the 4 matching pegs. Push open the service window to the right to find several jumpers. The jumpers in this window are designated for VGA port and COM port power supply function. Please consult your dealer for technical support on setup of these jumpers. Please note that only those

qualified technicians may adjust in the service window with information from Posiflex and the contents in the service window may change without notice as time

develops.Jumpers

RTC Battery
CAUTION	Service Window

Risk Of Explosion If Battery Is Replaced By An Incorrect Type

Dispose Of Used Batteries According To Local Regulations

SIDE & REAR TOP MOUNT UPGRADE KIT

Please follow the instructions in the manuals delivered with the side mount upgrade kit: KP100, SD100, SD200 or BC100U and the rear top mount upgrade kit PD302 to fit them in Jiva system construction.

Part 13