VI. Hardware Installation

A.Side Mount Upgrade Kit

When a side-mount upgrade kit option SD-300 or BC-300 is ordered with the LM/TM-7112, this option is already installed in the delivery. To assemble a separately delivered kit to the monitor, please use the 2 attached screws with washer to fix the kit to right side of LCD panel from back as revealed in rear view.

No matter the kit is BC-300 or SD-300 or whether the SD-300 kit itself contains MSR only, finger print sensor only or both options, the kit utilizes one USB cable. Connect it to one downlink USB port at right side of the base and insert it in the cable holder on back of LCD panel.

B.Cable Connections

1.Connect the VGA cable that has both 3 x 5 D sub male ends to VGA port at base rear bottom and the VGA port of host system. Screw in the cable to connectors at both ends.

2.Connect the USB cable that has one flat 4 pin connector (USB type A) and one square 4 pin connector (USB type B) to (uplink) USB port at base rear bottom and the USB port of host system.

3.For RS232 touch control type of TM-7112, connect the touch control cable that has one 9 pin D sub female end and one 10 pin RJ45 plug to RS232 port at base rear bottom and one COM port of host system. Make sure the plug clicks in. Screw fix the COM port end. This connection is not required for other models and therefore this cable will not be included for those models.

4.Connect USB device(s) like USB keyboard or USB mouse that would be more convenient for the user’s application to the (downlink) USB port(s). However please note that if the side mount kit is installed, there will be only one USB port left for this service.

5.Check the power adaptor against local power supply specifications. Connect the cable from the power adaptor to the DC jack at base rear bottom. Connect the power cable to the power adaptor and a clean power socket.

Part 4