Lathem DDC2, DDC4 manual Lathem Time Corporation

Page 2

OMNI:CHRON, mini:master, Lathem and the Lathem logo are registered trademarks of Lathem Time Corporation. Other product names mentioned in this manual may be trademarks of their respective companies and are hereby acknowledged.

WARNING: Changes or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.

Copyright © 2001 Lathem Time Corporation. All rights reserved.

Lathem Time Corporation

200 Selig Drive, SW

Atlanta, GA 30336

www.lathem.com

Document Number: USG0028D

Revised 11-19-2004

Image 2
Contents Installation & Users Guide Lathem Time Corporation Table of Contents Page Page Page Introduction Clock OperationAbout this Manual Optional Accessories DDC-TCPage Configuring the DDC Series Wall Clock Setting the DIP Switches DDC2 / DDC4 SeriesDIP Switch Settings DDC2/4-RS / DDC2/4-RS-24 Configuring RS485 Communications DDC2/4-RS SeriesBattery Usage DDC2 / DDC4 Series Battery Installation DDC2 / DDC4 Series Power Cord Installation DDC2/4-RSRS485 Wiring Wiring Installation DDC2/4-RS SeriesSecondary Wiring DDC-TC WiringBoard Layout Diagram Replacing an Existing DDC4 Wall ClockMounting DDC2 / DDC4 Series Mounting to a WallMounting to a Single Gang Box DDC2 Double Mount Wall DDC2 Double Mount Wall DDC4 Double Mount Wall Double Mount Ceiling DDC2 Double Mount Ceiling DDC4 Double Mount Ceiling Setting the Time Time FormatsBLK Appendix a DDC2-RS / 4-RS Secondary Clock Wiring DiagramsGrnd Stand-Alone 115VACWire Synchronous 115VAC BRN / WHT BLU / WHTAC RTN Wire Synchronous 24VACGrnd BLK BLUWire minute Impulse 59th Minute YEL / WHT VIO / WHT BRN / WHTWire Minute Impulse 59th Minute With 12 Hour Correction BLK YEL / WHT VIO / WHT BRN / WHTStandard Electric Synchronous Standard Electric AR-2A 2-Wire Dual Voltage BLK YELStandard Electric AR-2 2-Wire Dual Voltage Synchronous Wired Simplex 59th Minute Dual Motor Simplex 45th Minute Dual Motor Edwards Dual Motor Standard Electric AR-3 3-Wire Minute Impulse BLK YEL / WHT VIO / WHT BRN/ WHTNational Synchronous Wired Stromberg Synchronous Wired 56th Minute Common Cincinnati D1BLK VIO / WHT YEL / WHT Cincinnati D6, EdwardsWire Pulse Alternating 24VDC VIO / WHT YEL / WHTGrnd AC RTN BLK BLU Electronic CodedStraight Frequency Wire Minute Impulse 58th Minute Wire Minute Impulse 44th Minute Wire Reverse Polarity Minute Impulse 59th Minute Appendix B DDC2-RS-24 / DDC4-RS-24 Wiring DDC2-RS-24 / DDC4-RS-24 Wiring BLK BRN / WHT BLU / WHTAppendix C RS485 Wiring Diagrams RS485 Data FormatOmcii to DDC2-RS / 4-RS OMCGND BLK H LTR0 to DDC2-RS / 4-RSTerminal # Signal JP4 Connection LTR4 / 8-512 to DDC2-RS / 4-RSAppendix D DDC-TC Timer Control Panel WiringInstallation Timer ControlOperation As a Count Up Timer As a Count Down TimerAppendix E LTR-GPS Satellite Receiver / Clock Synchronizer DWA-SPage Connecting to a Lathem DDC2-RS or DDC4-RS Digital Clock Appendix F Specifications DDC2 / DDC4Appendix G Warranty Limited One-Year Limited Warranty
Related manuals
Manual 63 pages 22.4 Kb