SuperLoader™ 3A Series Quick Start Guide
Figure 3 Attaching Autoloader
Brackets
Autoloader
Screws
Autoloader bracket
3Using rack screws, attach a support bracket to the clip nuts on each rear rail (see figure 4.)
Note: Be sure to attach the support brackets correctly; the side of the bracket with only two holes should be secured to the rail.
Tighten the screws just enough to hold the support brackets firmly against the rail while still allowing the support bracket to be slightly shifted by hand. This shifting will help facilitate the engagement of autoloader brackets as the autoloader is installed in the rack. You will fully tighten the screws in step 8.
8 | Rack Mounting the Autoloader |