Starter Kit Instruction Manual | Safety Instructions | 11 |
3.3General safety instructions
•Never attempt to use a system for purposes other than those detailed in this manual.
•Never attempt to use a system in conjunc- tion with other instruments without obtain- ing prior information and approval from the manufacturer.
•Never attempt to use spare parts other than those supplied by the manufacturer.
•If an instrument is to be left unused for any length of time, protect the instrument against dust and/or humidity.
3.4Environmental conditions
•Like any other electrical device, the system must not be located near a water tap.
•The instrument must be kept away from po- tential sources of interference.
•The system must not be exposed to direct sunlight, heat, dust or excessive humidity (use only in a clean laboratory environment).
•Take care not to spill liquid on an instrument. In the event of accidental spillage, proceed as follows:
[1]Switch off the instrument immediately.
[2]Unplug the instrument from the mains.
[3]Wipe the instrument down with a dry tissue.
[4]Check all the electrical functions.
•Ensure sufficient ventilation of the instrument to prevent overheating.
3.5Compliance and informa- tion
In the event of operating faults or other technical incidents for which a remedy is not described in this manual, please contact the manufacturer or Alpes Lasers SA representative immediately.
(http://www.alpeslasers.ch/contacts.htm)