Detailed SET-UP Guide

NOTE: Fog and mist will not harm your remote sensor but direct rain must be avoided.

To complete the set up of your temperature station after the 10 minutes have passed please follow the steps starting on page 6.

Important: Insert batteries into the transmitter first, then into the alarm clock. Do not press any buttons until remote temperature is displayed.

I.BATTERY INSTALLATION

A.Remote Temperature Sensor

1.Remove the battery cover.

2.Observing the correct polarity, install 2 AA batteries.

3.The batteries will fit tightly to avoid start-up problems make sure that they do not spring free during installation.

4.Replace the battery cover.

B.Projection Alarm

Battery Cover

1.Remove the battery cover.

2.Observe the correct polarity, and install 3 AA batteries.

3.In addition to, or instead of inserting batteries, the AC adapter can be used. Simply insert the adapter into the receptacle on the underneath

of the alarm clock and then plug the adapter into the wall socket.

4.Replace the battery cover.

The projector will activate and remain on if the alarm clock is plugged in. If only batteries are used, the projector will only be activated when a button is pressed. The projection is a red light, not harmful under normal usage, although care should be taken to not look directly into the light.

Note: After the batteries have been installed a tone will sound, and the LCD (Liquid Crystal Display) will activate. The indoor temperature and the remote temperature will be displayed (within three minutes). Also, the time will appear as “-:--”. The WWVB search is automatically initiated, and a tower icon appears and flashes with the time colon (no tower icon will appear if the WWVB is too weak to be detected, and the time display will remain on “-:--”). While