La Crosse Technology WS-8236U To Install and Replace Batteries in the Atomic Clock, Setting UP

Page 2

TO INSTALL AND REPLACE BATTERIES IN THE ATOMIC CLOCK

The atomic clock uses 3 x AA, 1.5V batteries. To install and replace the batteries, please follow the steps below:

1.Pull down on the tab at the top of the battery cover and lift up to remove the cover.

2.Insert batteries observing the correct polarity (see marking inside battery compartment).

3.Replace compartment cover.

DO NOT SET THE CLOCK.

SETTING UP:

Alkaline batteries are recommended for use. Avoid using rechargeable batteries.

1.Place batteries in the atomic clock. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.

2.After 15 minutes the indoor area on your clock should have a temperature and humidity showing. If not, remove batteries, wait 15 minutes and repeat step one.

3.After the clock receives the WWVB time code reception will automatically start. This reception typically takes between 5-10 minutes in good conditions. If after 15 minutes the WWVB time has not been received, use the “SET” key to manually enter the set-up mode and change either the time or date in order to activate the WWVB reception (see manual settings below). The clock will then automatically attempt to receive the WWVB time from 12:00 am through 6:00 am each day (attempts WWVB reception every full hour within this time frame). When this is successful, the received time will override the manually set time. The date is also updated with the received time (Please refer to notes on “Radio controlled time” and “Manual time setting”).

4.After the time signal has been received or the search mode has been manually stopped the indoor temperature will be displayed.

Note:

When changing batteries in the unit, ensure that the batteries do not spring free from the contacts. Always wait at least 15 minutes after removing the batteries before reinserting, otherwise start up problems may occur.

FUNCTION KEYS

The atomic clock has four easy to use keys:

SET key : To enter into the set mode for the following functions: LCD contrast, time zone, DST ON/OFF (daylight saving time), radio-controlled time ON/OFF, language, hour, minute, year, month and date.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Features Atomic ClockFunction Keys To Install and Replace Batteries in the Atomic ClockSetting UP Do not SET the ClockManual Settings Atomic Clock LCD Screen DescriptionsLCD Contrast Setting Time Zone SettingDST Setting daylight saving time RADIO-CONTROLLED Time SettingLanguage Setting Manual Time SettingDate Setting Year SettingMonth Setting To Deactivate the Alarm Exit the Manual Setting ModesAlarm Setting Snooze SettingMoon Phase Wwvb Radio Controlled TimePositioning the Atomic Clock Moon Phases for the WS-8236UPositioning Foldout Table StandWall Mounting TroubleshootingCare and Maintenance Batteries Change SpecificationsLiability Disclaimer Warranty Information
Top Page Image Contents