WALL MOUNTING
1)Using a straight edge, horizontally space at about 2“ (50 mm) three screw positions on a wall.
2)Install three mounting screws (not included) into a wall
approximately 0.19“ (5mm) extended from the wall.
3)Place the atomic clock onto the screws, using the hanging holes on the
backside. Gently pull the atomic clock down to lock the screws into place.
Note:
Always ensure that the atomic clock locks onto the screws before releasing.
TROUBLESHOOTING
Problem: | The LCD is faint. | |
Solution: | 1) | Replace the batteries. |
Problem: | No reception of WWVB signal | |
Solution: | 1) | It may help reception to face the front of the atomic clock in the general |
|
| direction of Ft. Collins, Colorado. |
| 2) | Wait overnight for signal. |
| 3) | Be sure the atomic clock is at least 6 feet (2 meters) from any electrical |
|
| devices, i.e. TV sets, computers, or other radio controlled clocks. |
| 4) | Remove batteries for five minutes, reinsert and leave the unit alone |
|
| overnight without pressing any keys. |
Problem: | Hour is incorrect (minute and date are correct). | |
Solution: | 1) | Be sure the correct time zone and daylight saving time are selected. |
Problem: | "OFL“ appears in the indoor temperature section of the LCD | |
Solution: | 1) | Move the atomic clock to an area with warmer or cooler surrounding |
|
| temperature. Current surrounding temperatures are outside measuring |
|
| range. |
CARE AND MAINTENANCE:
•Avoid placing the unit in areas prone to vibration and shock as these may cause damage.
•Avoid areas where the unit can be exposed to sudden changes in temperature, i.e. direct sunlight, extreme cold and wet/moist conditions as these will lead to rapid changes which reduces the accuracy of readings.
11