La Crosse Technology WS8157U instruction manual Year Setting, Month Setting, Date Setting

Page 11

2.Set the desired hours by pressing and releasing the + key followed by pressing the SET key.

3.Now the minute digits will start flashing.

4.Set the desired minutes by pressing and releasing the + key. If the + key is held, the units will increase by 5.

5.Press and release the SET key to move to the “Year Setting”.

Note:

The unit will still try to receive the signal every day despite it being manually set. When it does receive the signal, it will change the manually set time into the received time. During reception attempts the WWVB tower icon will flash. If reception has been unsuccessful, then the WWVB tower icon will not appear but reception will still be attempted the following hour.

WWVB time reception takes place from 12:00 am through 6:00 am each day (attempts WWVB reception every full hour within this time frame). When the time signal is received for example at 1:00 am, the radio-controlled clock will not attempt to receive the WWVB signal for the remaining hours until 6:00 am. Therefore, the next signal attempt will take place between 12:00 am and 6:00 am the next day. The other times WWVB reception takes place, are upon setup and after manual time set exiting mode. Reception is generally not possible during daylight hours due to the interference of the sun.

YEAR SETTING

The year can be selected sequentially from 2003 to 2029 and will then start over again (default setting 2005). Only the last 2 digits of the year will be visible on LCD2. The year will only appear in the manual setting mode.

1.The year digits will start flashing on LCD2. Select the desired year by use of the + key.

2.Press and release the SET key to switch to the “Month Setting”.

MONTH SETTING

1.The month digits on LCD2 will start flashing. Set the desired month by use of the + key.

2.Press and release the SET key to move to the mode “Date Setting”.

DATE SETTING

1.The digits for the date will start flashing on LCD2 (Default setting 1). Set the desired date by use of the + key.

10

Page 10 Page 12
Image 11
Page 10 Page 12
Contents RADIO-CONTROLLED Clock with Outdoor Wireless Temperature Table of Contents Nist Glossary of Common TermsRADIO-CONTROLLED Clock FeaturesOutdoor Temperature Transmitter Do not SET the Clock Batteries ChangeDo not Press ANY Buttons for 15 Minutes SETTING-UPFunction Keys Weather Icons LCD Screen DescriptionsWeather Forecast Weather Tendency Arrows Manual SettingsDST Setting daylight saving time LCD Contrast SettingTime Zone Setting Or F Temperature Setting Time Reception Setting ON/OFFLanguage Setting 12/24 Hours Time Display SettingDate Setting Year SettingMonth Setting Alarm Setting Exit the Manual Setting ModesChanging the Display Mode DAY, SECONDS, and Temperatures 433MHz Reception Check for Outdoor Temperature Transmitter To Deactivate the AlarmSnooze Setting Outdoor Temperature TransmitterPositioning Wall Mounting Positioning the RADIO-CONTROLLED ClockFoldout Table Stand Mounting with Adhesive Tape Positioning the Outdoor Temperature TransmitterMounting with Screws Troubleshooting Specifications Care and MaintenanceWarranty Information Page FCC ID OMO-01RX Receiver OMO-01TX Transmitter FCC Disclaimer
Top Page Image Contents