POSITIONING THE RADIO-CONTROLLED CLOCK:
There are two possible ways to mount the radio-controlled clock:
•use of the foldout table stand, or
•wall mounting
FOLDOUT TABLE STAND
The foldout table stand leg is located on the backside. Pull the stand out from the bottom center edge of the radio-controlled clock, below the battery compartment. Once the foldout table stand is extended, place the radio- controlled clock in an appropriate location.
WALL MOUNTING
1)Using a straightedge, horizontally space at 2-3/4 of an inch (70 mm) three screw positions on a wall.
2)Install three mounting screws (not included) into a wall within
transmission range—leaving approximately 3/16 of an inch (5mm) extended from the wall.
3)Place the radio-controlled clock onto the screws, using the hanging holes on the backside. Gently pull the radio-controlled clock down to lock the screws into place.
Note:
Always ensure that the radio-controlled clock locks onto the screws before releasing.
14
