La Crosse Technology WS8157U Setting-Up, Function Keys, Do not Press ANY Buttons for 15 Minutes

Page 6

SETTING-UP:

Alkaline batteries are recommended for use in both units. Avoid using rechargeable batteries.

NOTE: Do not set-up the clock until the outdoor temperature is displayed.

1.Place batteries in the outdoor transmitter first, then into the radio-controlled clock.

DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.

2.After the 15 minutes both the Indoor and Outdoor areas on your clock should have a temperature showing. If not, remove both sets of batteries, wait 15 minutes and repeat step one.

3.After the clock receives the outdoor temperature, set your time zone using the manual settings below. The default (factory) time zone is Eastern Standard Time.

4.After the clock receives the outdoor temperature the WWVB time code reception will automatically start. This reception typically takes between 10-15 minutes in good conditions. If after 15 minutes the WWVB time has not been received, use the “SET” key to manually enter the set-up mode and change either the time or date in order to activate the WWVB reception (see manual settings below). The clock will then automatically attempt to receive the WWVB time from 12:00 am through 6:00 am each day (attempts WWVB reception every full hour within this time frame). When this is successful, the received time will override the manually set time. The date is also updated with the received time (Please refer to notes on “Manual time setting”).

Note:

In the event of changing batteries of the unit, ensure that the batteries do not spring free from the contacts. Always wait at least 15 minutes after removing the batteries before reinserting, otherwise start up and transmission problems may occur.

FUNCTION KEYS

The radio-controlled clock has four easy to use keys:

SET key

: To enter into the set mode for the following functions: LCD contrast, time

 

zone, DST ON/OFF (daylight saving time), time reception ON/OFF, language,

 

12/24 hour, ºC or ºF temperature, hour, minute, year, month and day display

+ key

: To toggle between the second, temperature or weekday display

 

To change any values in manual set mode

ALM key

: To enter into the alarm set mode

 

To set the alarm ON/OFF

SNZ key

: To activate the snooze function during alarm

 

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents RADIO-CONTROLLED Clock with Outdoor Wireless Temperature Table of Contents Glossary of Common Terms NistFeatures Outdoor Temperature TransmitterRADIO-CONTROLLED Clock Batteries Change Do not SET the ClockSETTING-UP Function KeysDo not Press ANY Buttons for 15 Minutes LCD Screen Descriptions Weather ForecastWeather Icons Manual Settings Weather Tendency ArrowsLCD Contrast Setting Time Zone SettingDST Setting daylight saving time 12/24 Hours Time Display Setting Time Reception Setting ON/OFFLanguage Setting Or F Temperature SettingYear Setting Month SettingDate Setting Exit the Manual Setting Modes Changing the Display Mode DAY, SECONDS, and TemperaturesAlarm Setting Outdoor Temperature Transmitter To Deactivate the AlarmSnooze Setting 433MHz Reception Check for Outdoor Temperature TransmitterPositioning Positioning the RADIO-CONTROLLED Clock Foldout Table StandWall Mounting Positioning the Outdoor Temperature Transmitter Mounting with ScrewsMounting with Adhesive Tape Troubleshooting Care and Maintenance SpecificationsWarranty Information Page FCC Disclaimer FCC ID OMO-01RX Receiver OMO-01TX Transmitter
Top Page Image Contents