PSC 4400 Series manual Removing the 4400 from the Dock

Page 23

Inserting/Removing the 4400

Removing the 4400 from the Dock

To remove the Falcon 4400 from the Dock:

1.Grasp the Falcon terminal.

2.Lift upwards while pulling the bottom of the terminal forward.

Figure 13. Removing the 4400 from the Dock

3.Slide the top of the Falcon out from under the top of the Dock. Removal of the Falcon from the Dock is complete.

Installation Guide

17

Image 23

Contents Falcon 4400 Series PSC Inc Table of Contents Appendix. Accessories and Peripherals Warranty PSC Falcon 4400 Series Powered Vehicle Dock WarrantyElectrical Warnings Safety PrecautionsDocument Conventions IntroductionManual Overview Features of the Powered Vehicle Dock About the Powered Vehicle DockUnpacking Electrical SpecificationsIntroduction Electrostatic Build-up Electrical ConsiderationsGround Contact Anti-Static Straps Installing Ground Contact Anti-Static StrapsElectrical Accessory Matrix Electrical AccessoriesConnection to +12V Electrical System ConnectionsOUT Connection to +24V, +36V and +48V SystemsElectrical Considerations Mounting Options Ram Ball Mounting AssemblyComponents, Materials and Tools Ram Ball Assembly sold separatelyAttaching the Ram Ball to the Vehicle Dock Final AssemblyInserting the 4400 in the Dock Inserting/RemovingInserting a Falcon 4400 in the Vehicle Dock Seat the bottom of the Terminal into the cradle on the Dock Removing the 4400 from the Dock Removing the 4400 from the DockMounting Options Connections on the Dock Power and Peripheral Device ConnectionsCOM Port Connections Power ConnectionBattery Charging Pin No Signal Power and Peripheral Device Connections PSC Technical Support Appendix a TroubleshootingHardware Troubleshooting Issues with Power to the DockTelephone Technical Support Overview Appendix B Accessories and PeripheralsAccessories and Peripherals Overview Kit, Inline Fuse 5 Amp Index Unpacking Warranty Page Index Page Asia Pacific Italy