Proview XAP series manual Method 2 Digital DVI Connection

Page 15

Installation

Method 2: Digital (DVI) Connection

1Turn off the computer and unplug the power cable.

2Connect the signal cable (DVI-I) to the DVI port on the back of the computer.

3Connect the audio cable to the line-in port on the back of the computer.

4Connect the power cord to wall outlet and LCD monitor.

5Press the POWER button, located on the bottom side of the main unit to turn the monitor on, then turn the computer on. If the monitor displays an image, the monitor is successfully installed. If no image is displayed, check all connections.

3 Connect to the Line-in port

2 Connect to the DVI port

4 Connect to power source

14	Xerox© LCD Monitor User’s Manual

Image 15

Contents LCD Monitor By Xerox Corporation. All rights reserved Table of Contents Europe Recycling PlaceCE Marking Declaration Of Conformity Federal Communications Commission FCC Statement Important Safety Instructions On next Collection service Introduction FeaturesPackage Contents DOWN/UP Front View and ControlsConnecting Your LCD Monitor to a Computer InstallationConnect the power cord to wall outlet and LCD monitor Method 2 Digital DVI Connection Digital Input Using Your LCD Monitor English First, release the LCD monitor’s stand lock 30o Next, adjust the height of the stand’s postInstalling the Wall Mount optional to Your LCD Monitor OSD Menu Using the OSD MenuOSD Options PhaseColor Select User ModeOSD Technical Information Preset Mode Timing ChartPIN Description DVI Connector PIN AssignmentSUB Connector PIN Assignment Plug and Play Visual InspectionPermanently unlit or lit pixels Poor picture or abnormal picture TroubleshootingMonitor will not turn on No pictureModel SpeciﬁcationsAuthorized Service Centers