Safety |
Restriction on Use
Grounding
Power Cord
Serviceability
Regulatory
Compliance
Use this equipment only for its intended use as described in this guide.
•Do not use power supplied outside the specified voltage/hertz range.
•Do not block any openings on the equipment.
•Do not use corrosive chemicals or vapors on the equipment.
•Do not expose equipment to rain or spills or moisture.
This equipment must be grounded to conform with the normative safety standards. Connect only to a properly grounded outlet.
The power cord supplied with the equipment is rated and approved for service to this equipment.
•Do not operate the equipment if it has a damaged power cord or plug.
•Do not immerse the power cord or plug in water.
•Do not use a power cord other than that supplied with the equipment.
There are no
FCC Compliance
This unit has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
CE Compliance
The manufacturer declares that this product conforms to the following standards or other normative documents:
EMC: EN 55022:1994 Limits and Methods of Measurements of Radio Interference Characteristics of Information Technology Equipment, Class A, including amendments A1:1995, A2:1997
EN 50024:1998 Limits and method of measurement of Immunity characteristics of Information technology equipment
Safety: EN 60950:1992 Safety of information technology equipment including electrical business equipment, including amendments A1:1993, A2:1993,
A3:1995, A4:1997, A11:1997
DT Chassis Printers/Plotters