5.Try printing a test disc after cleaning the cartridges. If it still is not printing properly, use a heavier level if the nozzles do not open up after using the light duty cleaning.
Tray Controller
The Rimage Tray Controller icon (
) is installed in the Windows Icon Tray once it was initiated. The tray controller must be running for the printer to function.
The Tray Controller application only runs if the operator starts the application. The Tray Controller is only available if the Liberty Printer Driver was installed. The Printer Tray opens only if the PC is connected to the printer and the Tray Controller is running.
Tray Controller Help
This section is a helpful procedure if the printer tray did not come out after pressing the disc button.
1.Make sure the USB cable is plugged in at the printer and the PC.
2.Make sure the tray controller application is running. This is seen in the icon tray as shown here.
3.Make sure the tray controller application has finished initializing, by
4.Check for the status. If the status is OK and there are no error messages in the tray controller application, close the tray controller application and unplug the USB cable from the printer.
5.Plug the USB cable back in the printer.
28