Topcom 4001G manual

Page 24

Parameter

Description

Wireless Mode

802.11 B/G mix – If you have a mix of 802.11b and 802.11g

 

wireless stations in your network, it is recommended to set the

 

adaptor to this mode. This mode is also the default setting.

 

802.11 B only – This adaptor can be compatible with both 802.11g

 

and 802.11b wireless stations. If there are only 802.11b wireless

 

stations in the network, you can set the adaptor to this mode.

 

802.11 G only – This adaptor can be compatible with both 802.11g

 

and 802.11b wireless stations. If there are only 802.11g wireless

 

stations in the network, you can set the adaptor to this mode.

Select Your Country Region Code

The available channel differs from different countries. For example:

 

USA (FCC) is channel 1-11, Europe (ETSI) is channel 1-13. The

 

operating frequency channel will be restricted to the country user

 

located before importing. If you are in different country, you have to

 

adjust the channel setting to comply the regulation of the country.

B/G Protection

If you have a mix of 802.11b and 802.11g wireless stations in the

 

network, it is recommended to enable the protection mechanism.

 

This mechanism can decrease the rate of data collision between

 

802.11b and 802.11g wireless stations. When the protection mode

 

is enabled, the throughput of the adaptor will be a little lower due to

 

many of frame traffic should be transmitted.

 

Auto – Based on the status of the network and automatically

 

disable/enable protection mode.

 

On – Always enable the protection mode.

 

Off – Always disable the protection mode.

Tx Rate

There are several options including

 

Auto/1/2/5.5/11/6/9/12/18/24/36/48/54Mbps for you to select.

 

When the “Auto” is selected, the device will choose the most

 

suitable transmission rate automatically. The higher data rate you

 

designated in the network, the shorter distance is allowed between

 

the adaptor and the wireless stations.

 

When the wireless mode is “802.11 B only”, the maximum data rate

 

is 11Mbps (11b) so that there are only “Auto/1/2/5.5/11Mbps”

 

options you can select.

Tx BURST

Tx Burst enables the adaptor to deliver better throughput in the

 

same period and environment.

21

Image 24
Contents Full User Guide Page Contents Introduction Features SpecificationsPackage Contents Installation Procedure Page Page Configuration Utility Site Survey Profile Configuration Page Authentication and Security Page Page Radius 1.3 802.1x Setting-Certification 1.4 802.1x Setting-CA Server Link Status Page Statistics AdvancePage Page Turbo Mode AboutPage Troubleshooting What is BSS ID? What is Spread Spectrum?