Model Name, Loudspeaker name, Configuration Name

8.0 SOFTWARE OPERATION

VNET CONTROL PANEL

The control panel for VNET“ allows VNET“ parameters to be viewed and adjusted. The panel is organised into a monitoring area (at the top left of the panel) where the status of VNET“ may be viewed, and a control area where all the controls to adjust parameters are located.

Note that Parameter adjustments are automatically stored in the DSP section of each VNET“ - it is not possible to do temporary changes then store them separately.

Parameters which can be adjusted by the user are: Crossover/Delay, EQ (Equalisation), Gain & Power.

The Crossover/Delay tab allows you to adjust the crossover frequencies, crossover shapes & delays.

The EQ sections (8 bands) allow you to adjust the frequency and level (boost/cut) for each of the equalisation filters, and the bandwidth (Q) of the bell equalisers. The latter controls allow the responsiveness of the filters to be adjusted either as bandwidth (Octaves) or Q. The up/down buttons will change the values. Values may be typed into either the bandwidth or Q part of the box. A ’Frequency Response’ curve˚shows the shape of each filter individually (by colour), and the combined effect of˚all equalisation (in white).

There are also High & Low shelving filters.

SPEAKER PROPERTIES

At the top of the panel there are several pieces of information about the connected device (which are only activated when going On-line to a device):

Model Name

The VNET“ model number

Loudspeaker name

To uniquely identify the speaker (i.e. delay 3)

Configuration Name

A name of up to 12 characters that you may enter as a name for the current set of parameters.

Firmware Version

A 4-digit hexadecimal number, acting as a signature for the current set of parameters. This may be used as a quick check that the parameters loaded into an X-Pod are as they should be.

Also see (Controls and Control Panels)

Keyboard Shortcuts
PodWare supports the following shortcuts :
Tab	Move to next control
In value boxes:
CTL+C	Copy
CTL+V	Paste
CTL+X	Cut
CTL+Z	Undo
On Drop-down, Spin, Push, Fader controls:
PgUp	Increase value (coarsely)
PgDown	Reduce value (coarsely)
Up/Right arrow	Increase value (finely)
Down/Left arrow	Reduce value (finely)
On push-button controls:
Space	Activate