TROY Group HP 4250 / 4350, HP 9050, HP 2420 / 2430 Hewlett-Packard 9050 Series Printers

Font Card Installation Guide

Hewlett-Packard 9050 Series Printers:

IMPORTANT: Ensure the printer power is switched OFF, and then disconnect the printer power cord from the AC wall outlet.

1.Loosen the two thumbscrews (turn counter-clockwise) at the rear of the printer (Figure 1 and Figure 2), and then carefully slide the formatter board out of the printer (Figure 3).

Carefully slide the formatter board out of the printer.

Figure 1 Figure 2 Figure 3

2.Set the formatter board on a clean flat surface (Figure 4). Insert the font card into card slot #2 (center card slot) as shown (Figure 5). The font card cannot be used in card slot #1. Do not remove or change the slot positions of any existing cards. Ensure the font card is fully inserted and seated against the connector.

2

3

	Insert font card
	into slot #2 only.
Figure 4	Figure 5

1

Document #50-70409-001 Rev. A Page 4 of 5