Trust Computer Products 802.11g manual Set the Static IP Address of the wireless cards

Page 10

108Mbps SuperG Wireless PCI Adapter

Please note that this type of installation requires that your ISP (Internet Service Provider) provide you a static IP address for each computer and the Access Point on your network. Please refer to the manual that came with your Access Point to determine its configuration.

Please follow these steps to complete the installation:

1.Connect the Wireless Access Point to a Broadband connection.

2.Install The 108Mbps SuperG Wireless PCI Adapter into the laptop computer(s) on your wireless network.

3.Check the Device Manager to confirm that the wireless card is installed correctly.

4.Set the Static IP Address of the wireless cards.

Note: The IP Address for all computers must be in the same IP Address range, and the Subnet Mask must be the same for all computers on your network. For example: If the first computer is assigned an IP Address of 192.168.0.2 with a Subnet Mask of 255.255.255.0, then the second computer can be assigned an IP Address of 192.168.0.x (where x is a number between 3 and 254) with a Subnet Mask of 255.255.255.0, etc.

If you are using a PPPoE client (Point to Point Protocol over Ethernet) please contact your ISP (Internet Service Provider) for further instructions regarding connecting to the Internet.

3. An Ad-Hoc Network

If you have two or more computers (desktops or laptops) and want to share files and printers, but no Internet connection, please complete the following instructions. When your Ad Hoc network is complete it may look similar to this:

(Requirements: Wireless network cards -for example, the 108Mbps SuperG Wireless PCI Adapter.)

To complete this installation, please follow these steps:

1.Install The 108Mbps SuperG Wireless PCI Adapter into your desktop computers.

2.Set the Static IP Address of the wireless cards.

Note: The IP Address for all computers must be in the same IP Address range, and the Subnet Mask must be the same for all computers on your network. For example: If the first computer is assigned an IP Address of 192.168.0.2 with a Subnet Mask of 255.255.255.0, then the second computer can be assigned an IP Address of 192.168.0.x (where x is a number between 3 and 254) with a Subnet Mask of 255.255.255.0, etc.

10

Image 10
Contents 108Mbps Super G Wireless PCI Adapter Contents Package Contents 108Mbps SuperG Wireless PCI Adapter IntroductionLeds Wireless Basics Standards Based TechnologyInstallation Considerations Getting Started Home Internet Network with Multiple IP Addresses Set the Static IP Address of the wireless cards To complete this installation, please follow these stepsInstall the 108Mbps SuperG Wireless PCI Adapter Check the Wireless Configuration for each wireless cardInstall your Internet Sharing Software Installation Installing the 108Mbps SuperG Wireless PCI Adapter 108Mbps SuperG Wireless PCI Adapter Ieee 802.11g PCI Card Wireless Network Adapter Installing The Configuration Utility Ieee 802.11g PCI Card Wireless Network Adapter Uninstalling the Configuration Utility Uninstalling the Driver Click on Device Manager108Mbps SuperG Wireless PCI Adapter Ieee 802.11g PCI Card Wireless Network Adapter Using the Configuration Utility for Windows Configuration TabAuthentication Data EncryptionStatus Tab Authentication StateSignal Strength Network TypeAdvanced State shows the Radio Status on or OFF Remember mini status position Enable IP setting and Proxy setting in profileDisable Radio Auto hide mini statusStart ad hoc network Power save ModeTransmit Power Ad-Hoc ChannelClick Properties Click Device ManagerRight-click on 108Mbps SuperG Wireless PCI Adapter Ieee 802.11g PCI Card Wireless Network Adapter Standards Media Access ControlDiagnostic LED Buy TypeTransmitter Output Power WeightPhysical Dimensions Humidity