SOYO SY-7IS2 user manual Voice Doctor, JP33 Setting, Clearing, JP5 Setting

Hardware Installation SY-7IS2

2-3.5 Voice Doctor

If the system does not boot-up properly, the Voice Doctor will inform the user by voice through internal/external speaker at what point in boot-up sequence the problem arises.

Below are the possible errors the user may encounter:

1.The Processor might be damage or not installed properly

2.The memory module might be damage or not installed properly

3.No Keyboard connected

4.VGA card might be damage or not inserted properly

5.Defective HD-Driver (IDE)

6.Floppy might havean error

Voice Doctor supports two language, refer the table below on the language you prefer.

Voice Doctor’s language

English Language

Chinese Language

JP33 Setting

Short pin 1-2

1 2 3

Short pin 2-3

1 2 3

2-3.6 CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to clear CMOS memory.

1.Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper can be easily identified by its white colored cap.

2.Then put the jumper back to 1-2 to allow writing of new data into the

CMOS memory.

CMOS	Clear CMOS Data				Retain CMOS Data
Clearing
	Short pin 2-3 for				Short pin 1-2
JP5 Setting	at least 5				to retain new
	seconds to clear				settings
	the CMOS	1	2	3	1	2	3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

41