SOYO SY-7IS2 user manual Power On, Cmos Setup Utility Copyright C 1984-2000 Award Software

Hardware Installation SY-7IS2

2-3.7 Power On

You have now completed the hardware installation of your Motherboard successfully.

1.Turn the power on

2.To enter the BIOS Setup Utility, press the <DEL> key while the system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot up sequence is completed. Then push the RESET button and press <DEL> key again at the beginning of boot-up, during diagnostic checks.

Repeat this operation until you get the following screen.

3. The BIOS Setup screen appears:

CMOS Setup Utility – Copyright ( C ) 1984-2000 Award Software

4Soyo Combo Feature	4PC Health Status
4Standard CMOS Features	Load Fail - Safe Defaults
4Advanced BIOS Features	Load Optimized Defaults
4Advanced Chipset Features	Set Supervisor Password
4Integrated Peripherals	Set User Password
4Power Management Setup	Save & Exit Setup
4PnP/PCI Configurations	Exit Without Saving
Esc : Quit	áâàß : Select Item
F10 : Save & Exit Setup

Change CPU’s Clock & Voltage

42