SOYO SY-D6IBA manual Select Soyo Combo Setup, Select Save & Exit Setup

Hardware Setup SY-D6IBA

3. Select [SOYO COMBO SETUP]

Move the cursor to the [CPU Frequency] field to set the CPU

working frequency, as shown in the following display.

			ROM PCI/ISA BIOS
			SOYO COMBO SETUP
			AWARD SOFTWARE, INC.
	CPU Frequency	: 233Mhz(66*3.5)		CPU Warning Temperature						: Disabled
	CPU Host Clock	: 66MHz		Current System Temp.						: 24°C/75°F
	CPU Ratio	: x 3.5		Current CPU1 Temperature						: 29°C/84°F
	CPU L2 Cache ECC Checking		: Enabled	Current CPU2 Temperature						: 29°C/84°F
				Current CPUFAN1 Speed						: 4891 RPM
	Boot Sequence	: A,C,SCSI		Current CPUFAN2 Speed						: 4891 RPM
				Current CPUFAN3 Speed						: 6553 RPM
	Quick Power On Self Test		: Enabled	CPU1(V)		: 2.81	V	CPU2(V)		: 2.81V
CPU Frequency				+3.3 V		: 3.40	V	+5	V	: 5.25V
	: 233Mhz(66*3.5)					: 12.16V		-12	V	: -12.15V
	POWER ON Function	: BUTTON ONLY		+12	V
				- 5	V	: - 5.26V
CPU Host Clock	KB Power ON Password	: Enter
	Hot Key Power ON	: Ctrl-F1		CPUFAN Off In Suspend						: Enabled
	: 66MHz
	Soft-Off by PWR-BTTN	: Instant-Off
CPU Ratio	Power-On by Alarm: x 3:.Disabled5
	Power-On by Ring/LAN	: Enabled		ESC	: Quit			− ↓ → ←		: Select Item
				F1	: Help			PU/PD/+/-		: Modify
				F5	: Old Values			(Shift) F2		: Color
				F6	: Load BIOS Defaults
				F7	: Load Setup Defaults

Available [CPU Frequency] settings on your SY-D6IBA Motherboard are detailed in the following table. If you set this field to [Manual], you are then required to fill in the next two consecutive fields: (1) the CPU Host Clock, and (2) the CPU Ratio.

CPU Frequency

233MHz (66 x 3.5)	350MHz (100 x 3.5)
266MHz (66 x 4.0)	400MHz (100 x 4.0)
300MHz (66 x 4.5)	450MHz (100 x 4.5)
333MHz (66 x 5.0)	500MHz (100 x 5.0)
366MHz (66 x 5.5)	550MHz (100 x 5.5)
400MHz (66 x 6.0)	600MHz (100 x 6.0)
433MHz (66 x 6.5)

Select the working frequency of your Pentium® III, Pentium® II, Celeron™ processor among these preset values.

Note: Mark the checkbox that corresponds to the working frequency of your Pentium® III, Pentium® II, Celeron™ processor in case the CMOS configuration should be lost.

4. Select [SAVE & EXIT SETUP]

Press <Enter> to save the new configuration to the CMOS memory,

and continue the boot sequence.

25