SOYO SY-D6IBA manual Power On, Power Button Enable JP2 Setting

Hardware Setup SY-D6IBA

Step 15. Power Button Enable (JP2)

Your system can be power on by either pressing a power button or typing in a password, which can be set in the BIOS SOYO COMBO Setup. To avoid being unable to power up the system due to of forgetting the password, you can place a jumper cap to short JP2. This will always enable the Power Button.

Power Button

Enable

JP2 Setting

Power Button always

enabled

Short pin to always enable the Power Button.

Power Button

according to BIOS

setting

Open pin for a Power Button function according to the BIOS setting.

Step 16. Power On

You have now completed the hardware installation of your Motherboard successfully.

1.Turn the power on

2.To enter the BIOS Setup Utility, press the <DEL> key while the system is performing the diagnostic checks,

Note: If you fail to enter the BIOS, wait until the boot up sequence is completed. Then push the RESET button and press <DEL> key again at the beginning of boot-up, during diagnostic checks.

Repeat this operation until you get the following screen.

23