Kenwood TS-570D, TS-570S Transmitting, Microphone Gain, Selecting Transmit Power

	4 OPERATING BASICS
TRANSMITTING	3 Press [PWR] again to complete the setting.
Methods for transmitting include the following:	Note: The transmit power can be separately selected for the AM
	mode independent of the other modes.
• Press [SEND].

1

•Press and hold down Mic [PTT].

•Connect a key or keyer paddle, select the CW mode, press [VOX] to switch ON the Break-in function, and close the key or keyer paddle.

PF POWER

ATT PRE-AMP

VOX	PROC
SEND	AT TUNE

For a detailed explanation on transmitting, refer to sections in “BASIC COMMUNICATING” beginning on page 20.

Note: When CW, FSK, or AM is selected, the transmit carrier level is automatically adjusted according to the selected mode.

MICROPHONE GAIN

The microphone gain is finely adjustable in the SSB or AM mode. A different level can be selected between when the Speech Processor {page 32} is ON and when the Speech Processor is OFF.

1Press [MIC].

•The current microphone gain level appears. The default is 50.

MIC

PWR

KEY

DELAY

2

3

4

5

6

SELECTING TRANSMIT POWER

It’s wise, and required by law, to select the lowest transmit power that allows reliable communication. Reducing power lowers the risk of interfering with others on the band. On this transceiver, it is possible to change output power while transmitting.

1Press [PWR].

• The current transmit power appears.

2Press [SEND] or press and hold Mic [PTT].

• “TX” appears.

3SSB: While speaking into the microphone, adjust the MULTI/CH control so that the ALC meter reflects according to your voice level.

AM: While speaking into the microphone, adjust the MULTI/CH control so that the calibrated power meter slightly reflects according to your voice level.

7

8

9

MIC

PWR

KEY

DELAY

2Turn the MULTI/CH control counterclockwise to reduce power and clockwise to increase power.

• The displayed transmit power changes.

CH

QUICK MEMO

•SSB/CW/FSK/FM:Transmit power can be changed from 5 W to 100 W in steps of 5 W.

•AM:Transmit power can be changed from 5 W to 25 W in steps of 5 W.

CH

QUICK MEMO

4Press [SEND] again or release Mic [PTT].

• “TX” disappears.

5Press [MIC] again.

For the FM mode, set the microphone gain by accessing Menu No. 17 {page 17} and selecting either “L” (low) or “H” (high).

Note:

◆When using the optional MC-90 microphone in FM mode, select high microphone gain. The microphone sensitivity is low in FM mode and this may cause insufficient modulation.

◆When using a microphone that has an amplifier, be careful that the output of the amplifier is not too large.

10

11

12

13

14

15

16

15