1
10 MEMORY FEATURES
■ | MEMORY RECALL AND SCROLL |
2
3
4
1Press [A/B] to select VFO A or VFO B.
•“tA” or “tB” appears to show which VFO is selected.
2Select the frequency, mode, etc. to be stored.
•The frequency and mode selected here will be used for transmitting.
3Press [A/B] to select the other VFO.
4Select the receive frequency and mode.
5Press [SPLIT].
•“SPLIT” appears.
There are two modes that allow you to retrieve frequencies and associated data that you stored in a memory channel: Memory Recall and Memory Scroll.
Memory Recall:
In this mode, the transceiver receives and transmits using a frequency that you retrieve. You can temporarily change the frequency and associated data without overwriting the contents of the memory channel.
Memory Scroll:
Use this mode to check the contents of memory channels without changing the current receive frequency. In this mode, frequencies that you retrieve are not used for receiving and transmitting.
5
6
7
8
9
10
11
12
6Press [M.IN] to enter Memory Scroll mode.
•To exit Memory Scroll mode and abort the storage process, press [CLR].
7Turn the MULTI/CH control, or press Mic [UP] or [DWN] to select a memory channel.
•Entering a
■Memory Recall
1Press [M/V] to enter Memory Recall mode.
•The memory channel that was last selected appears.
2Turn the MULTI/CH control, or press Mic [UP] or [DWN] to select a memory channel.
•Continuously holding down Mic [UP] or [DWN] steps the transceiver through the memory channels until the button is released.
•The memory channels that contain no data are skipped.
•You cannot change memory channels while transmitting.
3To exit Memory Recall mode, press [M/V].
Note: Memory channels can also be changed while using the
| 8 Press [M.IN] again to store the data. |
13 | • The previous data stored in the channel is |
overwritten. |
14
15
16
Note: When subtone frequencies differ between TX and RX while performing
40
