Kenwood TS-570D, TS-570S, TS-570S, TS-570D instruction manual Your

2 YOUR FIRST QSO

TRANSMITTING

ro

YOUR

ti we

PF	POWER
					HF TRANSCEIVER TS-570D
ATT	PRE-AMP
VOX	PROC
SEND	AT TUNE
		CH1	CH2	CH3	MIC	LSB
PHONES		1	2	3
						USB
		ANT	REC	FINE	PWR	CW
		4	5	6
						FSK
MIC		NB	AGC/TONE REV		KEY
						FM
		7	8	9
						AM
			F.LOCK		DELAY	MENU 1MHz

CLR 0 ENT

						DSP SLOPE
					N.R.	HIGH	LOW
					B.C.	T	I
						U	H
							G
						C	H
						W	C
				CW TUNE		O
						L	TU
				FILTER
				RIT/XIT		AF	RF
	UP					4	6
DOWN		MR
			M.IN	–	+	2	8
						0	10
SPLIT	TF-SET	A/B	RIT	CH	IF SHIFT		SQL
						4	6
M/V	A=B	CLEAR	XIT
						2	8
SCAN	M>VFO		M.IN
						0	10

FIRST QSO

qu

After tuning in a few stations as explained in the previous section “RECEIVING”, try making a contact.

qAssuming you are already on the correct band with the correct mode selected (steps 1~7 in “RECEIVING”), use the Tuning control to tune in a station or to select an unused frequency.

wMomentarily press the [AT TUNE] button.

• “AT” appears.

ePress and hold the [AT TUNE] button to allow the built-in antenna tuner to function.

• “AT” blinks and “TX” appears.

rSSB: Press the [MIC] button to activate the Microphone Gain Setting function.

• “MIC-50” appears.

CW: Skip this step.

tPress the [SEND] button.

•“TX” appears.

yBegin speaking into the microphone or sending CW with your key.

uSSB: While speaking into the microphone, adjust the MULTI/CH control so that the ALC meter reflects according to your voice level.

•Tuning should be completed in less than approximately 20 seconds. “AT” stops blinking and “TX” disappears.

•If tuning is not completed in approximately 20 seconds, error beeps sound. Press

[AT TUNE] to stop the error beeps and to quit tuning. Check your antenna system before continuing.

Note: Tuning will automatically turn off after approximately

60 seconds. In addition, “AT” will disappear and the error beeps will stop.

CW: Skip this step.

iPress the [SEND] button again when you want to return to receive mode.

oPress the [MIC] button again to quit the Microphone Gain Setting function.

This completes your introduction to the TS-570, but there is a great deal more to know. “OPERATING BASICS” {page 13} and following chapters explain all functions of the transceiver starting with the most basic, commonly-used functions.

5