Kenwood TS-570S, TS-570D VS-3 Voice Synthesizer Unit, Filters, Installing Options

Models: TS-570D, TS-570S TS-570S, TS-570D

1 89
Download 89 pages 39.8 Kb
Page 64
Image 64

1

2

3

4

5

6

7

8

9

14 INSTALLING OPTIONS

VS-3 VOICE SYNTHESIZER UNIT

3 Remove the 2 screws from the OPTION FILTER

 

section of the transceiver PC board.

CAUTION: SWITCH OFF THE POWER AND UNPLUG THE DC

POWER CABLE BEFORE BEGINNING INSTALLATION.

1 Remove the bottom case (8 screws).

2 Hold the VS-3 unit with the component side facing inward, and insert the VS-3 connector into the transceiver CN16 connector.

Component side

VS-3

CN16

4 Align the pins of the transceiver CN8 and CN9 connectors with the two connectors on the filter.

• Take care to properly align the pins.

Filter

3 Replace the bottom case (8 screws).

Note: The VR8 allows you to adjust the volume for voice announcement. Use only when the volume level is too low or too high.

CN8

CN9

VR8

5 While holding the filter, carefully push down until the filter snaps into place.

10

11

12

13

YK-88C-1/ YK-88CN-1/ YK-88SN-1

FILTERS

CAUTION: SWITCH OFF THE POWER AND UNPLUG THE DC POWER CABLE BEFORE BEGINNING INSTALLATION.

1Remove the 2 screws from the bottom cover of the

transceiver.

Bottom cover

6Re-install the 2 screws that you removed in step 3.

7Replace the bottom cover (2 screws).

Note: After installing the filter, be sure to select the appropriate setting in Menu No. 46; otherwise the filter will not function.

14

15

16

2Remove the bottom cover.

58

Page 64
Image 64
Kenwood TS-570S, TS-570D, TS-570D, TS-570S instruction manual VS-3 Voice Synthesizer Unit, Filters, Installing Options