Graco 2M06 Battery Installation, Using AC Adapters, Low Battery

Battery Installation

Parent Unit

The Parent Unit is shipped with rechargeable batteries already installed. The battery must be plugged into the Parent Unit before the unit will be ready for use.

• Remove the battery door cover on the Parent Unit with a key or flat blade screw driver.

• Lift the battery out of the compartment, and carefully plug the battery into the unit.

•Replace the battery and the battery door cover.

•If it becomes necessary to purchase a new battery, remove the cover, carefully unplug the battery and replace with a new battery.

Replace the battery door cover.

Using AC Adapters

•The Parent Unit can use either the rechargeable battery that comes with the unit or standard 120 volt AC household current. The Nursery Unit uses standard 120 volt AC household current.

•To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the Parent Unit and the Nursery Unit. Then plug adapter into a standard wall outlet.

•Use ONLY the Graco adapters included with the unit. Do not use these adapters with other equipment under any circumstances.

•If units do not work, check that AC adapters are plugged into working outlets.

•When electricity is off (from a power failure, etc.), the Parent Unit will operate on rechargeable batteries, however, the Nursery Unit will not operate until power is restored.

Low Battery

Parent Unit

• When the battery is low in the parent unit you may plug in the A/C adapter to recharge the batteries.

Out of Range Indication

•If the Parent Unit begins to lose the signal from the Nursery Unit you may hear static or other noise. Immediately move the Parent Unit closer to the Nursery Unit to regain connection.

***Note: It is not uncommon for the Parent Unit to occasionally lose and regain connection with the Nursery Unit in environments that have a significant amount of obstructions.

3