Motorola CPCI-6020 manual Installing and Removing the Transition Module, 140

Transition Module Preparation and Installation Installing and Removing the Transition Module

7.7Installing and Removing the Transition Module

Personal Injury or Death

Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing and adjusting.

Product Damage

Avoid touching areas of integrated circuitry; static discharge can damage these circuits.

Installation Procedure

After all peripheral modules have been installed and all of the appropriate jumpers have been set, you are ready to install the transition module in its chassis slot. At this point, follow the steps below:

1.Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove the chassis or system cover(s) as necessary for access to the chassis backplane.

3.With the CPCI-6020-MCPTM-01 in the correct vertical position that matches the pin positioning of the backplane, carefully slide the transition module into the appropriate slot and seat tightly into the backplane.

4.Secure in place with the screws provided, making good contact with the transverse mounting rails to minimize RF emissions.

5.Replace the chassis or system cover(s), reconnect the system to the AC or DC power source and turn the equipment power on, or if hot swapping, you may now install the CPCI-6020.

140 CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)