Motorola CPCI-6020 manual Installing the SIMs

Installing the SIMs Transition Module Preparation and Installation

Procedure

You must set the jumpers and install the SIMs prior to installing the CPCI-6020-MCPTM-01 transition module in the system chassis.

1.Align the SIM so that P1 on the SIM align with the appropriate SIM connector (J12 for COM3 and J13 for COM4) on the transition module. Note the position of the alignment key on P1. Refer to the following figure.

2.Place the SIM onto the transition module SIM connector, making sure that the mounting holes also align with the standoffs on the transition module as shown in the following figure.

SIM Alignment

CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C) 137