Motorola CPCI-6020 manual PMC Module Installation

PMC Module Installation Hardware Preparation and Installation

3.Carefully remove the CPCI-6020 from the CompactPCI card slot and place it on a clean and adequately protected working surface with connectors J1 through J5 facing you.

Product Damage

Avoid touching areas of integrated circuitry; static discharge can damage these circuits.

Before touching the board or electronic components, make sure you are working in an ESD-safe environment.

4.Remove the PCI filler from the front panel.

5.Slide the edge connector of the PMC module into the front panel opening from behind and place the PMC module on top of the baseboard. The four connectors on the underside of the PMC module should then connect smoothly with the corresponding connectors (J11/12/13/14) on the CPCI-6020.

6.Insert the four short phillips-head screws (provided with the PMC) through the holes on the bottom side of the CPCI-6020 and the PMC front bezel and into rear standoffs. Tighten the screws.

7.Reinstall the CPCI-6020 assembly in its proper card slot. Be sure the module is well seated in the backplane connectors. Do not damage or bend connector pins.

8.If the PMC module was installed in a non-hot swap chassis, replace the chassis or system cover(s), reconnect the system to the AC or DC power source and turn the equipment power on.

CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C) 45