Motorola CPCI-6020 manual Installing the PIM

Installing the PIM Transition Module Preparation and Installation

6.Slide the face plate (front bezel) of the PIM module into the front panel opening from behind and place the PIM module on top of the transition module, aligned with the appropriate two PIM connectors (P0 and P4). The two connectors on the underside of the PIM module should then connect smoothly with the corresponding connectors on the transition module (J10 and J14). Refer to the following figure for proper screw/board alignment.

PIM Alignment

7.Insert the four short Phillips screws, provided with the PIM, through the holes on the bottom side of the transition module into the PIM front bezel and rear standoffs. Tighten the screws.

8.With the CPCI-6020-MCPTM-01 in the correct vertical position that matches the pin positioning of the backplane, carefully slide the transition module into the appropriate slot and seat tightly into the backplane.

9.Secure in place with the screws provided, making good contact with the transverse mounting rails to minimize RF emissions.

10.Replace the chassis or system cover(s), reconnect the system to the AC or DC power source and turn the equipment power on, or if hot swapping, you may now install the CPCI-6020.

CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C) 139