Motorola CPCI-6020 manual Startup and Operation, Power-up Procedure

Hardware Preparation and Installation Startup and Operation

If your module is hot swap compliant and you are running fully functional hot swap- aware software, unlatching this ejector lever will start the shutdown process on the board.

4. Carefully pull the module from the chassis.

2.14Startup and Operation

This section describes startup information used with the CPCI-6020 family of single board computers in a system configuration. The information includes system considerations, a brief explanation and graphic of the power-up sequence performed by the firmware.

Power-up Procedure

Perform the following steps to ensure proper board operation:

1.Before applying power, ensure you configure the hardware properly (for example, jumper settings, memory installation, flash installation, PMC installation and other hardware features).

2.Check all connections and ensure the installation is complete (cabling, transition module connections, if applicable).

3.Once everything is verified, power up the system.

When the power is turned on, the MPU, the hardware and the firmware initialization processes are performed. The firmware initializes the devices on the CPCI-6020 in preparation for booting the operating system.

The firmware is shipped from the factory with an appropriate set of defaults. In most cases, it is not necessary to modify the firmware configuration before booting the operating system.

54 CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)