Motorola CPCI-6020 manual Installing the SIMs, 136

Transition Module Preparation and Installation Installing the SIMs

Figure 7-6 EIA-232-D DTE Ports 3 and 4 Configuration
Z85230 SCC					COM3 COM4
TXD				TXD	1	26
RTS#				RTS#	3	28
RXD				RXD	2	27
CTS#				CTS#	4	29
DCD#				DCD#	7	32
		3		ETXC	23	48
TRXC		2		TXC#
		1			14	39
RTXC	J3/MX	J17, J16		RXC	16	41
Z8536 CIO					J1	J1
DTR#				DTR	19	44
LLB#				LL	17	42
RLB#				RL	20	45
DSR#				DSR#	5	30
RI#				RI#	21	46
TM#				TM#	24	49
				GND#	6	31
CPCI-6020		CPCI-6020-MCPTM-01
			EIA-232-D DTE SIM
		Transition Module			HD-26

7.5Installing the SIMs

Configure the serial ports 3 and 4 (COM3/COM4) for the required interface by installing the appropriate SIM. Refer to Table 7-3 on page 142 for a list of the serial port interface types.

Prior to installing the SIMs, be sure you have set the jumper(s) on J16 (for serial port 3) and/or J17 (for serial port 4), as described in the previous section for either DCE or DTE. The SIMs plug into connectors J12 (COM3) and J13 (COM4) on the CPCI-6020-MCPTM-01. Refer to Figure 7-4 on page 133 for connector and header locations.

Install the SIMs on the CPCI-6020-MCPTM-01 transition module using the following procedure:

136 CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)