Motorola CPCI-6020 manual Debugger Commands, Command Description

Debugger Commands Firmware

The later is accomplished by entering HE, followed by a space, followed by the test category description (e.g., UART), followed by a carriage return.

Table 5-1 Debugger Commands

	Command	Description
	AS	Assembler
	BC	Block of Memory Compare
	BF	Block of Memory Fill
	BFL	Flash Board Fail LED If Diagnostic Errors
	BI	Block of Memory Initialize
	BM	Block of Memory Move
	BS	Block of Memory Search
	BR	Breakpoint Insert
	BV	Block of Memory Verify
	CACHE	Modify Cache State
	CM	Concurrent Mode
	CNFG	Configure Board Information Block
	CS	Checksum a Block of Data
	CSAR	PCI Configuration Space READ Access
	CSAW	PCI Configuration Space WRITE Access
	DC	Data Conversion and Expression Evaluation
	DS	Disassembler
	DU	Dump S-Records
	ECHO	Echo String
	ENV	Set Environment to Bug/Operating System
	FORK	Fork Idle MPU at Address
	FORKWR	Fork Idle MPU with Registers
	G	"Alias" for "GO" Command
	GD	Go Direct (Ignore Breakpoints)
	GEVBOOT	Global Environment Variable Boot - Bootstrap Operating System
	GEVDEL	Global Environment Variable Delete
	GEVDUMP	Global Environment Variable(s) Dump (NVRAM Header + Data)
	GEVEDIT	Global Environment Variable Edit
	GEVINIT	Global Environment Variable Area Initialize (NVRAM Header)
	GEVSHOW	Global Environment Variable Show
	GN	Go to Next Instruction
	GO	Go Execute User Program
	GT	Go to Temporary Breakpoint
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)			111