System Considerations

Hardware Preparation and Installation

 

 

The following flowchart shows the basic initialization process that takes place during system startup. Refer to a detailed initialization list in Chapter 5, Firmware, on page 107.

Figure 2-3 Start Up Flow Diagram

Startup

System

Initialization

Console Detection

Run Self Tests

(if enabled)

Auto Boot

(if enabled)

Operating

System

2.15System Considerations

The CPCI-6020 is designed to operate as a CompactPCI system slot board. As a system slot board, the CPCI-6020 provides system clocks and arbitration for other peripheral slots in the subrack. Consequently, the CPCI-6020 must be installed in a subrack system slot marked with a triangle symbol.

The CPCI-6020 provides seven peripheral slot clock outputs (CLK0-CLK6) per CompactPCI specification 2.0 R2.1. Arbitration for the seven peripheral slot bus masters is provided by the CPCI-6020.

On the CPCI-6020 baseboard, the standard serial console port (COM1) serves as the PPCBug debugger console port. The firmware console should be set up as follows:

zEight bits per character

zOne stop bit per character

zParity disabled (no parity)

zBaud rate of 9600 baud

CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)

55

Page 55
Image 55
Motorola CPCI-6020 manual System Considerations