Motorola CPCI-6020 manual Installing and Removing a Module

Installing and Removing a Module Hardware Preparation and Installation

2.13Installing and Removing a Module

This section describes a recommended procedure for installing and removing a board module in a chassis. Before you install your module, please read all cautions, warnings and instructions presented in this section and the guidelines explained in Before You Install or Remove a Board on page 47.

Installation Procedure

Hot swap compliant modules may be installed while the system is powered on. If a module is not hot swap compliant, you should remove power to the slot or system before installing the module. See Understanding Hot Swap on page 48 for more information.

Signaling Requirements

Ensure the backplane does not bus J3, J4 or J5 signals to other slots.

Set the VIO on the backplane to either +3.3 V or +5 V, depending upon your system’s signaling requirements.

CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C) 51